Velkommen til SpeakOn.no

Laney GH50R Rørtopp EL34

Bilder

Laney GH50R Rørtopp EL34
kr 10 495,00

Art.nr.: p110590


På vårt lager :

Utsolgt

Men fortvil ikke, varen leveres på få dager dersom varen er på lager hos leverandør. Ta gjerne kontakt.

GH50R er en 50W helrørs-kombo utstyrt med to stk EL34 utgangsrør og to stk Celestion Vintage 30 element. GHR-serien er resultatet av Laneys dyptgående studier om hvordan gitarister interagerer med rørforsterkere. To lydelementer, rødt og svart, beskriver preamprørenes dist og utgangsrørenes dist og GHR lar deg stille inn perfekt balanse mellom disse.
• SpeakOn AS tar forbehold om eventuelle skrivefeil og prisendringer.
OR
Beskrivelse

Details

An amp tweakers’ delight

The GH50R gives something back to the modern guitar player that for too many years has been overlooked. In a world obsessed by pre-amp distortion, the dark art of power amp distortion has been lost – until now. The GH50R delivers transparent, versatile classic rock tones with the ability to blend in the dynamic characteristic of pre-amp distortion and power amp distortion right there at your fingertips. Both channels on the GH50R produce the same tonal characteristic but how you set them up gives you the subtle difference that tone hounds dream about. This is the ‘amp tweakers’ delight! Whether it’s funk or melodic rock, whether you’re a hybrid picker or a shredder, the GH50R delivers outstanding, dynamic, complex, harmonically rich controllable tone.

Digital Reverb

Digital Reverb

Studio quality digital reverb with Pull focus

XLR-DI OUT

XLR-DI OUT

The XLR-DI out allows you to connect your amplifier to a PA system or recording interface, without the need for micing. It is fully balanced and features a level switch for -30dB (PA/Desk level) or +4dB (Line level) for driving powered cabinets directly. The XLR-DI out also features a ground lift switch is also provided for lowest noise performance. Unlike most other XLR-DI out, the Laney fitted XLR-DI out is post the output section of the amp.

Pull Shift on Mid EQ

Pull Shift on Mid EQ

Pulling on each of the EQ control knobs will shift the response of each control as follows: Bass: Deep - This extends the low-end frequency response, resulting in a fuller, heavier sound for lower notes. Mid: Shift - This lowers the frequency range of the mid control to give a tighter sound. Treble: Shift - This broadens the Treble control frequency response, to give a rounder sound to higher notes, especially when used with thin sounding pickups.


  • Switchable cabinet emulation


  • FS2-MINI included


  • FX loop series/switchable level


  • Premium Hand selected ECC83 & EL34 tubes


  • Slip cover supplied


  • 2 Channels


  • 50 watts RMS


  • The ability to blend the amount of preamp and output distortion

Specifications

  • Extension speaker socket: 1 x 16 Ohm, 1 x 8 Ohm, 2 x 16 Ohms, 1 x 4 Ohms & 2 x 8 Ohms
  • Master Tone & Master Output
  • Item dimensions: 235mm x 675mm x 285mm (HWD)
  • Carton dimensions: 331mm x 824mm x 349mm (HWD)
  • Item weight: 19.00kg